Koala Kare Baby Changing Station Installation With Metal Wall Studs

The bed and metal mounting chassis and the wall mount liner dispenser.

Koala kare baby changing station installation with metal wall studs. Masonry or tile over stud wall use a 7 32 6 mm masonry drill bit for the pilot hole until you hit the stud. Koala kare kb20000 horizontal baby changing station 35 3 16 x 22 1 4 cream. By opening the metal mounting chassis remove the wall mount liner dispenser and place it aside. Lifting the bed and metal mounting chassis the installer rests the chassis key holes slots on the exposed mounting screws.

Use a stud finder to locate the studs mark the location with a pencil. The packaged product has two pieces. Having located the studs measure across sixteen inches the mounting distance horizontally between the screws. The unit must be attached to a permanent wall that is capable of holding a substantial load.

For metal stud or concrete block if the wall has wood studs that are not on 16 406 mm centers has metal studs or an underlying surface of concrete block drill with a masonry bit. To meet the ada requirement measure forty four and a quarter inches from the floor on stud center to what will be the top screw. If the wall has wood studs that are not on 32 81 cm centers has metal studs or an underlying surface of concrete block drill with a 1 27 cm masonry bit. Gosh those key holes make installation easy.

The maximum recommended total weight for this baby changing station including baby and parcel bag is 60 lbs. You may have to purchase toggles before installing you must allow a minimum of 2 64 mm of inside wall space for toggles to turn. Change bit to 1 8 32 cm regular drill bit. Kb200 installation instructions us kb200 ss installation instructions us kb200 inb installation instructions int l kb200 ss installation instructions int l kb100 installation instructions.

Installation instructions baby changing stations. Koala baby changing stations have been tested to hold a substantial static load. A level is used to ensure the unit is mounted straight.